|
THERMAX MARINE systems are offered with laminate (HPL) surface thus covering an extensive range of decorative colors and patterns to chose from, combined with durability, scratch and impact resistance; all systems are compatible and can be combined to meet the requirements of today’s design standards for high class accomodations. THERMAX Tresista and Light Weight Tresista with a flush panel joint are modular panels for quick installation without the necessity of cutting on board.
|
|
Technical Data THERMAX MARINE BOARDS
|
|
 THERMAX MARINE products are tested for environmental safety and are approved by all major certification authorities worldwide.
Acoustic performance
Authorities, owners and designers require an extended level of noise control on board ships or in offshore accommodation.
THERMAX MARINE Systems offer a wide range of solutions from simple 30 dB partitions to advanced HNR-panels achieving 43 dB in a high class standard with all benefits of a hard plastic laminate surface. Being fully compatible, HNR-panels can be specific for cabin/cabin partitions, Light Weight Tresista with 33 dB for cabin/corridor partition and 21 mm THERMAX MARINE panels for lining, public spaces, etc. thus saving total weight and costs.
|
|
Visit THERMAX at their official web site
|
|
 Durability
THERMAX boards and Rockwool core provide a stable substrate for plastic laminate surfaces and are not affected by changes of temperature and humidity under normally accepted living conditions. Hard plastic laminates with their high resistance against scratching and cleaning agents and high impact strength make it a very durable and maintenance free surface.
However, plastic laminate surfaces in general cannot be recommended for areas where there is a likelihood of relative humidity falling below 30% R. H. Because of shrinking stress in the laminate this very dry condition could affect the glueline or cause cracks in the laminate.
In addition, in case of a fire, no hydrochloric or similar corrosive gases are generated which could cause severe damages especially to electric and electronic equipment.
|
|
Workability
THERMAX non-combustible boards are flat rectangular boards with a smooth and even surface. They contain no cement or other aggregates which could significantly affect the service life of tools. Conventional joiners tools and woodworking machinery can be used.
MORE
|
